For a removable weighted blanket cover, measure the insert laid flat, map the centre of every loop and check that the opening is large enough to insert and remove the blanket. The nominal size printed on a label does not tell you the finished dimensions, edge thickness or tie placement. Test a paired sample before ordering replacement covers in bulk.
Measure seam to seam and agree the orientation
Lay the insert on a flat surface with no pull at the corners. Measure finished length and width seam to seam, and note the edge thickness and binding. Pick an orientation, such as label at the bottom, and use the top-left corner in that orientation as the origin. If you only have a drawing, request a physical sample before final approval.
Map the loops so the cover can be cut and sewn to match
Draw the insert as a rectangle. Plot each loop from the chosen origin or mark its distance along a named edge from a defined corner. Label inside or outside placement and describe how the loop is oriented. Do the same on the proposed cover for the tie points. Confirm the two drawings represent the same dimensions and layout when the cover is fitted, rather than comparing a face-up drawing to its mirror.
| Fit field | چه چیزی را ضبط کنیم |
|---|---|
| Insert body | Flat width and length, edge thickness, label orientation. |
| Attachment points | Point ID, edge, position along the edge and loop description. |
| Cover opening | Usable opening length, edge and distance from the corner. |
| Assembled sample | Loop reach, corner fit, closure movement and areas where the insert bunches. |
Run a paired fitting check
Inspect the cover opening on the finished sample. Insert the actual blanket without pulling on the ends of the opening. Fasten the ties, close the cover and lay it flat. Check for extra fabric around the corners, gaps caused by misalignment and whether the zipper passes the insert clear of fabric. Remove it once to see whether it can be serviced easily. Approve the cover and insert as a pair by revision, and record separate care instructions for both.
Send the measurements with the order brief
Include the dimensioned drawing, target fabric, quantities by size and any label or pack instructions. The removable cover page is the place to identify the proposed cover; the weighted blanket range helps identify an insert. Consult the weighted blanket care guide before specifying cleaning for either part. Request a paired cover and insert sample and attach the point map.
سوالات متداول
Will the same size name fit blankets from different suppliers?
Size names do not establish seam-to-seam dimensions or loop placement. Check a specific insert and cover pair against your approved measurement sheet.
Is loop count enough for a compatible cover?
No. Record where each loop sits, its orientation and how it joins the proposed tie.
What should I check if a blanket is difficult to put into the cover?
Check usable opening length and edge, insert thickness, and whether the zipper or stitching is being forced. Recheck the paired prototype before approving either dimension.




